Dodge Dakota Sport 2001 Service Manual page 555

8P - 4 SPEED CONTROL
CABLE (Continued)
(8) Remove servo cable from servo. Refer to Speed
Control Servo Removal/Installation.
Fig. 3 Cable Connectors at Bell Crank—4.7L V-8
1 - THROTTLE BODY
2 - SPEED CONTROL CABLE CONNECTOR
3 - OFF
4 - OFF
5 - ACCELERATOR CABLE CONNECTOR
6 - CABLE CAM
7 - BELLCRANK
INSTALLATION - EXCEPT 4.7L
(1) Install end of cable to speed control servo.
Refer to Speed Control Servo Removal and Installa-
tion.
(2) Install cable into throttle body mounting
bracket (snaps in).
(3) Install speed control cable connector at throttle
body bellcrank pin (snaps on).
(4) 2.5L Engine: Install cable to cable guide at top
of valve cover.
(5) Connect negative battery cable at battery.
(6) Before starting engine, operate accelerator
pedal to check for any binding.
INSTALLATION - 4.7L
(1) Install end of cable to speed control servo.
Refer to Speed Control Servo Removal/Installation.
(2) Slide speed control cable plastic mount into
bracket.
(3) Install speed control cable connector onto throt-
tle body bellcrank pin (snaps on).
Engine
Fig. 4 Accelerator Cable Release Tab—4.7L V-8
1 - ACCELERATOR CABLE
2 - PLASTIC CABLE MOUNT
3 - PRESS TAB FOR REMOVAL
4 - CABLE BRACKET
5 - SLIDE FOR REMOVAL
(4) Slide accelerator cable plastic mount into
bracket. Continue sliding until tab (Fig. 4) is aligned
to hole in mounting bracket.
(5) Route accelerator cable over top of cable cam
(Fig. 3).
(6) Install accelerator cable connector onto throttle
body bellcrank pin (snaps on).
(7) Install air box housing to throttle body.
(8) Connect negative battery cable at battery.
(9) Before starting engine, operate accelerator
pedal to check for any binding.
SERVO
DESCRIPTION
The servo unit consists of a solenoid valve body,
and a vacuum chamber. The solenoid valve body con-
tains three solenoids:
• Vacuum
• Vent
• Dump
The vacuum chamber contains a diaphragm with a
cable attached to control the throttle linkage.
Engine
AN