Clutch Pedal - Dodge Dakota Sport 2001 Service Manual

AN
LINKAGE (Continued)
1 - CLUTCH FLUID RESERVOIR

2 - CLUTCH PEDAL

3 - CLUTCH SAVE CYLINDER
4 - CLUTCH HYDRAULIC LINE
5 - CLUTCH PEDAL
(13) Verify that fluid line from master cylinder to
slave cylinder is properly routed.
CLUTCH PEDAL
REMOVAL
(1) Remove retaining clip securing push rod on
clutch pedal (Fig. 16).
(2) Slide push rod off clutch pedal pin.
(3) Remove snap ring and washer attaching clutch
pedal to the pivot shaft.
(4) Slide pedal off pivot shaft and remove pedal.
(5) Remove and inspect bushings in pedal bore.
Replace bushings if worn or cracked.
INSTALLATION
(1) Lubricate pedal bushings and shaft with a sili-
cone grease or with Mopar multi-mileage grease.
(2) Install bushings in pedal bore and on pin.
Fig. 15 Clutch Hydraulic Linkage
6 - CLUTCH PEDAL POSITION SWITCH CONNECTOR
7 - CLUTCH HYDRAULIC LINE
8 - CLUTCH MASTER CYLINDER
(3) Install pedal on pivot shaft.
(4) Secure pedal on shaft with washer and snap
ring.
(5) Apply light coating of grease to the inner diam-
eter of the master cylinder push-rod and the outer
diameter of the clutch pedal pin.
(6) Connect push rod to pedal and secure rod with
retaining clip.
CLUTCH PEDAL POSITION
SWITCH
DESCRIPTION
A clutch pedal position switch is in the starter cir-
cuit. The switch is located on the clutch master cyl-
inder push rod.
CLUTCH 6 - 15