Dodge Dakota Sport 2001 Service Manual page 545

8O - 28 RESTRAINTS
REAR SEAT BELT & RETRACTOR (Continued)
Fig. 24 Rear Seat Belt & Retractor - Club Cab
1 - TURNING LOOP
2 - LAP BELT/BUCKLE ANCHOR
3 - BUCKLE/BUCKLE ANCHOR
4 - LOWER ANCHOR
5 - RETRACTOR
(3) Remove the shoulder belt turning loop from the
quarter inner panel (club cab) or the C-pillar (quad
cab).
(4) Remove the trim from the quarter inner panel
(club cab) (Refer to 23 - BODY/INTERIOR/QUAR-
TER TRIM PANEL - REMOVAL) or the C-pillar
(quad cab) (Refer to 23 - BODY/INTERIOR/C-PIL-
LAR TRIM - REMOVAL).
(5) Remove the screw that secures the lower seat
belt anchor plate to the quarter inner panel (club
cab) or the C-pillar (quad cab).
(6) Remove the lower seat belt anchor plate from
the quarter inner panel (club cab) or the C-pillar
(quad cab).
(7) Remove the screw that secures the retractor to
the quarter inner panel (club cab) or the C-pillar
(quad cab).
(8) Remove the rear shoulder belt and retractor
from the quarter inner panel (club cab) or the C-pil-
lar (quad cab).
INSTALLATION
WARNING: DURING AND FOLLOWING ANY SEAT
BELT SERVICE, CAREFULLY INSPECT ALL SEAT
BELTS, BUCKLES, MOUNTING HARDWARE, AND
RETRACTORS FOR PROPER INSTALLATION,
Fig. 25 Rear Seat Belt & Retractor - Quad Cab
1 - TURNING LOOP
2 - SCREW
3 - COVER
4 - LOWER C-PILLAR TRIM
5 - SCREW
6 - SCREW
7 - RETRACTOR
8 - UPPER C-PILLAR TRIM
OPERATION, OR DAMAGE. REPLACE ANY BELT
THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN
ANY BELT THAT IS TWISTED. TIGHTEN ANY
LOOSE FASTENERS. REPLACE ANY BELT THAT
HAS A DAMAGED OR INOPERATIVE BUCKLE OR
RETRACTOR. REPLACE ANY BELT THAT HAS A
BENT OR DAMAGED LATCH PLATE OR ANCHOR
PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT
COMPONENT. ALWAYS REPLACE DAMAGED OR
FAULTY SEAT BELT COMPONENTS WITH THE COR-
RECT, NEW AND UNUSED REPLACEMENT PARTS
LISTED IN THE MOPAR PARTS CATALOG.
(1) Position the retractor onto the quarter inner
panel (club cab) (Fig. 24) or the C-pillar (quad cab)
(Fig. 25).
(2) Install and tighten the screw that secures the
retractor to the quarter inner panel (club cab) or the
C-pillar (quad cab). Tighten the screw to 40 N·m (29
ft. lbs.).
(3) Position the lower seat belt anchor plate onto
the quarter inner panel (club cab) or the C-pillar
(quad cab).
(4) Install and tighten the screw that secures the
lower seat belt anchor plate to the quarter inner
AN