Tail Lamp - Dodge Dakota Sport 2001 Service Manual

AN
PARK/TURN SIGNAL LAMP (Continued)
INSTALLATION
(1) Install park and turn signal lamp bulb in
socket.
(2) Install park and turn signal lamp socket into
back of lamp.
(3) Install park/turn signal lamp.
(4) Connect the battery negative cable.

TAIL LAMP

REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove screws from tail lamp.
(3) Grasp lamp, firmly pull lamp rearward to dis-
engage retaining studs.
(4) Remove sockets from tail lamp (Fig. 18).
(5) Pull bulb from socket.
(6) Separate tail lamp from cargo box.
Fig. 18 Tail, Brake, Turn Signal And
1 - TAIL/STOP/TURN SIGNAL LAMP BULB
2 - BACK-UP LAMP BULB
INSTALLATION
(1) Install bulb in socket.
(2) Install socket in tail lamp.
(3) Position tail lamp in cargo box, engage retain-
ing studs and install screws.
(4) Connect the battery negative cable.
TAIL LAMP UNIT
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Release tailgate latch and open tailgate.
LAMPS/LIGHTING - EXTERIOR
(3) Remove screw holding tail lamp to cargo box
(Fig. 19).
(4) Grasp lamp, firmly pull lamp rearward to dis-
engage retaining studs.
(5) Remove sockets from tail lamp.
(6) Separate tail lamp from cargo box.
Fig. 19 Tail Lamp
1 - CARGO BOX
2 - TAIL/STOP BACK-UP LAMP
3 - ROUND CLIP
INSTALLATION
(1) Install sockets in tail lamp.
(2) Position tail lamp at cargo box, engage retain-
ing studs (Fig. 20) and install screw.
(3) Close tailgate.
(4) Connect the negative battery cable.
Fig. 20 Retaining Studs
1 - RETAINING STUDS
2 - TAIL LAMP
8L - 23