Drop Address DIP Switch Location
ASCII Address and
Communication
Parameter Switches
(J892 Only)
REAR OF A J892 INTERFACE
Figure 33 J89O/J892 Dip Switch Locations (Rear of Modules)
Procedure Set Drop Address/ASCII
Ports
for
J89X 81
Install
Step 1
Using drop address switch shown in Figure 34, set Drop
address as shown in Table 5-l below. The address is
equal to the binary value plus 1. The White portion of the
switch in the illustration represents the switch rocker in the
set position. In the example below the address is set to 2.
70
System Installation
GM-0984-EDK