Panel/Bulkhead Mounting - Black & Decker d984 Installation Manual

Panel/Bulkhead Mounting
As shown in Figure 18 and Figure 19 below, the housing has keyholes at the top
and bottom of the housing for bulkhead mounting purposes. The keyholes are
sized for 5/l 6-inch bolts. The recommended ground point is also shown.
Procedure
Step 1
Step 2
Step 3
Panel/Bulkhead Mounting Installation
Install and ground your bulkhead mounting surface for
Drop 2.
Layout your drop based on your RI/O configuration diagram
and installation plan.
Install l/4 inch inserts into the panel or metal mounting sur-
face for your primary housing as shown in Figure 18 and
Figure 19.
44
System Installation
GMa984-EDK