La Crosse Technology WS-2308 Operation Manual page 15

However if you wish to make a full reset of the base station and return
to the original factory settings, simultaneously press and hold the
PRESSURE and WIND keys for about 5 seconds. The base station will
beep once and the entire LCD will light up for 5 seconds and go back to
the original factory settings. This process with clear all previous user
defined values and all weather history recordings.
Factory default settings:
The following table shows the factory default values of the weather
station:
Matter:
Time
Date
Time zone
Alarm time
Relative air pressure
Weather-picture threshold
LCD contrast level
Rainfall per impulse
Storm alarm
Relative air pressure
alarm
Indoor temperature alarm
Outdoor temperature
alarm
Indoor humidity alarm
Outdoor humidity alarm
Wind chill alarm
Dew point alarm
Rainfall 24h alarm
Rainfall 1h alarm
Wind Speed
Wind direction alarm
Note:
All alarm default values are deactivated at the start up and any alarm
must be activated by the user otherwise it will not sound.
Default Setting:
0:00
01.01.2001
0
0:00
1013.0 hPa
3 hPa
5 (1-8 levels)
0.518mm
5 hPa
960.0 hPa 1040.0 hPa
(low) (high)
10.0ºC (low) 30.0ºC (high)
0.0ºC (low) 40.0ºC (high)
35%RH (low) 65%RH (high)
45%RH (low) 70%RH (high)
10.0ºC (low) 30.0ºC (high)
0.0ºC (low) 30.0ºC (high)
50.0mm
1.0mm
1km/h (low) 100km/h (high)
None set
57