Content, Scope And Purpose; Organization - Garmin GTN 6 series Maintenance Manual

1 INTRODUCTION

1.1 Content, Scope and Purpose

This document provides Instructions for Continued Airworthiness (ICA) for the GTN 6XX/7XX and
GMA 35 as installed under STC SA02019SE-D. This document satisfies the requirements for continued
airworthiness as defined by 14 CFR Part 23.1529 and 14 CFR Part 23 Appendix G. Information in this
document is required to maintain the continued airworthiness of the GTN 6XX/7XX and GMA 35.

1.2 Organization

The following outline briefly describes the organization of this manual:
Section 2: System Description
Provides a description of the equipment installed by STC SA02019SE-D. An overview of the GTN and
GMA 35 system interface is also provided.
Section 3: GTN Control and Operation
Presents basic control and operation information specifically tailored to maintenance practices. Basic GTN
Configuration Mode operation is also described as well as loading of software.
Section 4: Instructions for Continued Airworthiness
This section provides maintenance instructions for continued airworthiness of the GTN and GMA 35
systems.
Section 5: Troubleshooting
This section provides troubleshooting information to aid in diagnosing and resolving potential problems
with the GTN and GMA 35 equipment.
Section 6: Equipment Removal & Replacement
This section provides instructions for the removal and replacement of the GTN and GMA 35 equipment.
Section 7: Equipment Configuration & Testing
This section provides instructions for the configuration and testing of the GTN and GMA 35 equipment.
Section 8: System Return to Service Procedure
This section specifies return-to-service procedures to be performed upon completion of maintenance of the
GTN and GMA 35 equipment.
190-01007-A1 System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
Rev. 6 Page 1-1