Pioneer f-502 Service Manual page 81

PDP436PU, PDP506PU, PRO436PU, PRO506PU
SYSTEM RESET THROUGH SERVICE MODE
After Replacing Main Assy in G-6 Media Receiver or G-7 panel
In order to enter Service Mode, TV guide must be turned off
In order to do this procedure you must have and use the correct remote. The full function remote that
came with the set has a TV Guide Logo in a red box. This is the remote you should use.
NOTE: If TV guide has not yet been setup, then the 1st step is to follow instructions to set TV guide up.
Enter ZIP code, cable or ant. etc.
Then:
1. press and release the "TV Guide". TV guide will appear on the screen.
2. Navigate to the TV Guide tool bar and use the ">" button to select "setup" in the menu and press
and release the "enter" button
3. use the "arrow down" button to select "default options"
4. press and release the "enter" button and select "general defaults"
5. press and release the "enter" button (opens menu on lower left side)
6. use the "arrow down" button to select "auto guide"
7. use the ">" button to select "off"
8. use the "arrow down" button to select "done"
9. press and release the "enter"
10. press and release the "TV Guide" button to turn the display off
1. Enter Service Mode
2. Use the "muting" button to select "initialize" screen
3. While on the "initialize" screen
4. Use the "down arrow" button to select "final setup"
5. Press and release the "enter" button to select "data reset"
6. Use the ">" button on the remote to select "yes"
7. Press and hold the "enter" button until the screen goes black release "enter" button on remote.
8. Power the unit off using the remote control
9. Unplug the power cord from the media receiver to complete the reset
10. Plug in the media receiver; turn the system on and reset is complete.
When Replacing Main Assy in G-6 Media Receiver or G-7 panel
Press and release "HOME MENU" and "POWER" buttons in sequence on the remote control. Unit will power up
in "INTERGRATOR"mode.
Hold the DISPLAY button on the remote until "data reset or all reset" appears then release button.
Press Right ">" button to select "yes" then release button
Press and hold ENTER button on remote until test screen disappears. Release button.
Unplug power cord from media receiver to complete reset. Wait 30sec.
Plug in media receiver power cord, turn system on and reset is now complete
TV Guide option must be turned off
TO TURN OFF TV GUIDE
System Reset Using Service Mode:
Method Using Integrator mode:
81
How to enter the Factory Mode by Remote
control.
① Turn off the TV Guide feature
② Set unit to Standby Mode
③ Press and release the DISPLAY Button
④ Wait 4 seconds
⑤ LEFT Button
(ß)
⑥ UP Button
(á)
⑦ LEFT Button
(ß) - Within 5 seconds
⑧ RIGHT Button
(à)
⑧ POWER Button