Sharp UX-108 Service Manual page 13

3. 12. Entry data receive
In this mode, the registered data sent from the other machine are re-
ceived and the received data are registered in the own machine. When
this mode is used for receiving, the other machine must be in the entry
data send mode.
After receiving is completed, the following lists are printed.
1. Telephone list data
2. Sender register data (The passcode No. is also printed if the poling
function is provided.)
3. Optional setting list
4. Soft switch content
5. Junk fax number list
6. Timer reservation list (only model which timer communication is
possible)
4. How to make soft switch setting
To enter the soft switch mode, make the following key entries in sequence.
Press FUNCTION
DATA No.
S F T SW-A1 = 0 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A2 = 0 0 0 0 0 0 0 0
S F T SW-L2 = 0 0 0 0 0 0 0 0
9 8
1 2 3 4 5 6 7 8
The soft switch mode is terminated.
3. 13. Cutter aging (Cutter model only)
The mode is used to continuously cut the recording paper to approx. 10
mm and display the number of cutting times.
(Unless the memory clear is executed, the number of cutting times is
integrated.)
In the following cases, the operation is stopped.
1. The stop key is continuously pressed.
2. There is no recording paper.
3. The recording paper is jammed.
7 START
Press FUNCTION key.
Press
Press
Bit1 - 8 are set.
Press
START
Soft SW-A2 - SW-L2 are set.
To finish the settings halfway between
SW-A1 and SW-L2, press the STOP
key. In this case, the setting being done
to the SW No. on display will be nullified
while settings done to the preceding
SW Nos. remain in effect.
When the COPY key is pressed, the
contents of soft switches are printed.
2 – 4
UX-108U/178U/188U
FO-375U
START
key.
key.
key during setting.