ParaBody 375101 Assembly Instructions Manual page 22

33
ADUST!
26
30
FIGURE 27
STEP 27
CABLE ADJUSTMENT
• The following adjustments can be made to adjust the cable tension:
• If upon completion of assembly, the HEAD PLATE (26) does not sit on top of the first WEIGHT PLATE (31), push the HEAD PLATE (26)
down, insert the WEIGHT STACK PIN (30) and perform several repetitions at the press station. This will relax the cable system and
prevent the HEAD PLATE (26) from lifting up.
• If there is still excess slack in the cables, loosen and adjust the PULLEY attached to the slotted tab on the BENCH FRAME (2).
• If after completing previous step, the HEAD PLATE (26) still does not sit on top of the first WEIGHT PLATE (31) or if there is excess slack
in the cable system, adjust the threaded end of the PRIMARY CABLE (33) accordingly and retighten the jam nut.
• IMPORTANT! Retighten the jam nut when adjustment is completed
Thank you for purchasing the Parabody 375101 Home Gym. If unsure of proper use of equipment, call your
local Parabody distributor or call the Parabody customer service department at (800) 328-9714.
ADUST!
.
22