ParaBody 375101 Assembly Instructions Manual page 13

STEP 15
• Securely assemble the WEIGHT STACK SHAFT
(27) to the HEAD PLATE (26) using one 3/8 X 1-
1/4" BOLT (63) and one 3/8" LOCK WASHER
(52).
• Insert two GUIDE RODS (19) into the BASE (1) as
shown on FIGURE 15. (NOTE: Lubricate GUIDE
RODS (19) with silicon or teflon spray available
at most hardware stores.)
• Slide two 1-1/4 X 4-7/8" TUBES (18), two 3/4"
WASHERS (56), and two WEIGHT STACK
CUSHIONS (29) - IN THAT ORDER - down over
the GUIDE RODS (19).
• Using EXTREME CARE slide all fifteen WEIGHT
PLATES (31) down over the GUIDE RODS (19) on
to the WEIGHT STACK CUSHIONS (29). Make
sure that the keyholes of the WEIGHT PLATES
(31) are all facing the right way.
• Slide the head plate assembly down over the GUIDE
RODS (19) onto the weight stack.
• Insert two CAP PLUGS (45) into the top ends of the
GUIDE RODS (19).
• Attach the WEIGHT STACK LABELS (71) to the
weight stack. Also insert the WEIGHT STACK PIN
(30) into the first WEIGHT PLATE (31) of the weight
stack.
51
64 3/8 X 2"
19
26
3/8" LOCK WASHER 52
3/8 X 1-1/4" 63
31
71
30
29
56
18
FIGURE 15
46
50
34
11
FIGURE 16
13
45
27
STEP 16
• SECURELY assemble one 3-1/2" PULLEY
(34) to the FLOATING PULLEY BRACKET
(11) using one 3/8 X 2" BOLT (64), two 3/8"
WASHER (51), and one 3/8" LOCKNUT (50)
as shown in FIGURE 16.
• Assemble one 2" SQ. RUBBER BUMPER
(46) to the FLOATING PULLEY BRACKET
(11) as shown in FIGURE 16.
1