Advertisement
NOTE: THE LEG PRESS ATTACHMENT (832101)
MUST BE ASSEMBLED BEFORE ASSEMBLING
TO THE PARABODY 350.
PLEASE ASSEMBLE THE LEG PRESS ATTACHMENT AT THIS
TE~IE USING THE 832 PRODUCT ASSEMBLY INSTRUCTIONS.
Insert
two (2) 2 SQ. IN. PAKABODY COVER CAPS onto the BASE CONNECTION WELDMENT
shown on drawing.
Remove middle 4-1/2 X I IN. PULLEY, 3/8.X 1-3/4 IN. BOLT, and 3/8 IN. LOCK ]xrUT from the 350
BASE.
3o
Kemove the SECONDARY (LOWER) CABLE from the 350.
4.
NOTE: The SECONDARY (LOWER) CABLE will
no longerbe
needed.
o
SECURELY assemble the BASE CONNECTION WELD1VIENT to the 832 using two (2) 3/8 X 3 IN.
BOLTS, four (4) 3/8 IN. WASHEILS, and two (2) 3/$ IN. LOCK NUTS.
LOOSELY
assemble one {I) 4-112 X ) IN. PULLEY, from step 2, to the lower hole on th¢t right side
the BASE CONNECTION WELDMENT
using one (1) 3/8 x 2 IN. BOLT, one (1) 2-718 IN. CABLE
RETAINING CLIP, and one (I) 3/8 IN. LOCK NUT.
o
I0.
LOOSELY assemble one (1) 3-1/2 X 1 IN. PULLEY to the upper hole on the left side ofl~e BASE
CONNECTION WELDMENT using one (1) 3/8 x 2 IN. BOLT, one (1) 2-3/8 IN. CABLE RETAINING
CLIP, and one (I) 3/8 IN. LOCK NUT,
LOOSELY assemble one (1) 3-1/2 X 1 IN. PULLEY to the middle pulley fiat of the 350 BASE using one
(1) 3/8 x 2 IN. BOLT, one (1) 2-3/8 IN. CABLE RETAINING CLIP, and one (1) 3/8 IN. I.,OCK
SECURELY attach
the BASE CONNECTION WELDMENT
and the 832 to the base of the 350 using
two(2) 3/8 X 3 IN. BOLTS, four (4) 3/8 IN. WASHEKS, and two C2) 3/8 IN. LOCK NUT;S.
Following the cable routing diagram, thread the LEG PRESS CABLE from the SWIVEL LOW ROW
through the BASE CONNECTION
WELDMENT
and around the pulley in the 832. (The pulley,
wheels,
and spacers may need to be temperately" removed) and to the ezra on the LEG CURL/EXT.
11.
SECURE end of LEG PRESS CABLE to the cam using the hardware removed in step 3.
12.
SECURELY tighten all pulley connections, making sure that the CABLE RETAINING CLIPS are facing
the correct direction as shown in drawing.
13.
If upon completion of assembly, the head plate does not sit on top of first weight plate or there is excess
slack in the cable system, refer to your 350 ASSEMBLY
INSTKUCTIONS. (NOTE: Some slack in the
cable system is needed to allow for pre-streteh adjustment in the 832 leg press.)
Part # 6638101
2
Revision: 06/03/96
Advertisement
