Checking And Previewing Edit Points - Panasonic VQT9958 Operating Instructions Manual

CONTENTS
Automatic editing

Checking and previewing edit points

1
Press the IN (or OUT) button to check the edit
point. The value of the registered edit point
appears on the display panel.
2
While holding down the IN (or OUT) button, press
the PREROLL button and check the picture at the
edit point.
The tape is cued up to the edit IN (or OUT) point,
and a still picture of the point appears.
O If STOP has been selected as the setup menu
No. 315 (AFTER CUE-UP) setting or if the
MODE switch has been set to EE, the VTR is
set to the E-E mode.
3
By holding down the IN and OUT buttons at the
same time, check the editing duration.
The duration appears on the display panel.
How to calculate the duration
O When two edit points have been set:
Duration between the two points
O When only one edit point has been set:
Duration between the data which has been
set and the current address
O When no edit points have been set:
Duration of the previously edited section
4
After the edit points have been registered, press
the PREVIEW button.
Regular preview is now conducted.
<Notes>
O If the edit IN point has not been registered, the
position where the PREVIEW button was
pressed is registered as the edit IN point.
O To stop the preview at any time, press the
STOP button.
O When the PREVIEW button is pressed again
after the IN point during the course of a preview,
the preview will start again from the beginning.
O When the edit OUT point is reached, the tape
stops automatically.
(deck-to-deck) SD955
ON
OFF
METER
FULL/FINE
MONITOR SELECT
HEADPHONES
23 (E)
POWER DVCPRO 50
DVCPRO
DV
COUNTER ASSEM VIDEO
RESET CH1 CH2 CH3
L
INSERT
R
A IN
TRIM
PREVIEW/PREVIEW AUTO EDIT PREROLL SET
MONITOR MIX INPUT SELECT
IN
VIDEO AUDIO
CH1 CH2 CH3 CH4 TC
PRESET MENU SET DIAG
UNITY
REC LEVEL
PB LEVEL VAR
4 2 1/3
STAND BY PLAYER RECORDER JOG SHTL SLOW
CUE TC
CH4
EDIT PLAY REC
A OUT
REW STOP FF
OUT
SUPER REC INH INT TCG MODE CONTROL
REGEN
ON ON TAPE REMOTE
PRESET
OFF OFF EE LOCAL
EXIT