Toshiba e-STUDIO455 Series Scanning Manual page 19

2.BASIC OPERATION
If the equipment is either the e-STUDIO4520C Series or the e-STUDIO6530C Series, press [PREVIEW] here
and then select the scanning function in order to preview the scanned data at the end of the operation. For
instructions on how to preview your scans, see the following section:
P.44 "Previewing Scans"
4
Make sure that [MFP LOCAL] is selected and highlighted.
Proceed to Step 9.
If [USB MEDIA] is selected, you cannot select [MFP LOCAL]. When you want to select [MFP LOCAL], press
[USB MEDIA] to cancel the selection.
If saving data in a network folder is enabled by the administrator, you can select 2 file destinations from
[MFP LOCAL] or [USB MEDIA], [REMOTE 1] and [REMOTE 2]. If you select [MFP LOCAL], you can specify
a network folder (REMOTE 1 or 2) as a remote destination. To set a network folder as a remote destination,
proceed to Step 7.
5
To store the scan in the USB storage device, connect
the device to the equipment and wait a few seconds.
Connect the USB storage device to the USB port.
To find out the location of the USB port on the equipment, refer to
the Quick Start Guide.
2 BASIC OPERATION
USB Port
USB Storage Device
Scan to File or USB 17