Feed Dog Height - ELNA eXplore 240 Service Manual

MECHANICAL ADJUSTMENT

FEED DOG HEIGHT

TO CHECK:
1. Lower the presser foot.
2. Turn the handwheel toward you to bring the feed dog to its highest position. The height of the feed
dog from the needle plate should be 0.75 to 0.90 mm.
If it is not in the range, adjust as follows.
ADJUSTMENT PROCEDURE:
1. Open the bed cover plate.
2. Lower the presser foot and turn the handwheel toward you until the feed dog comes to its highest
point.
3. Loosen the screw (A) .
4. Turn the feed lifting pin to adjust the height of feed dog (0.75–0.90 mm).
5. Tighten the screw (A).
6. Turn the handwheel toward you to recheck the height of feed dog.
Needle plate
0.75 to 0.90mm
Feed lifting pin
15
MODEL:eXplore 240
(A)