Feed Dog Height - ELNA Elnita ec60 Service Manual

MECHANICAL ADJUSTMENT

FEED DOG HEIGHT

The highest position of the feed dog should be between 0.80 and 0.90 mm from the surface of the needle
plate.
1. Lower the presser foot and turn the power switch on.
2. Turn the handwheel toward you to set the feed dog at the highest position.
3. Remove the free arm cover.
4. Loosen the setscrew (A) and nut (B).
5. Adjust the feed dog height by turning the adjusting screw (C). The highest position of the feed dog
should be between 0.80 and 0.90 from the surface of the needle plate.
6. Tighten the nut (B) and setscrew.
7. Attach the free arm cover.
Presser foot
Surface of the needle
Feed dog
plate
0.80 to 0.90 mm
(A)
(A)
(B)
14
(C)