Vision Fitness E3100 Assembly Manual page 6

PINK BAG
2
STEP
• Slide the console mast cover onto
Tension Knob
the console mast.
Bracket
• With the included wire-tie, pull the
wire harness, or sensor wire through
Tension Knob
the console mast. Insert the console
Console Mast
mast into the mast mounting-bracket.
Secure in place with seven screws
(M8x15L) and six lock washers (M8).
Tighten with the 5mm Allen wrench.
Console Mast
NOTE: The screw facing the seat
Cover
does not use a lock washer. Tighten
this screw until snug. Slide the console
mast cover down over the screw heads.
• MODEL E3000: Snap the tension
knob mounting bracket onto the ten-
Mounting
sion knob. Turn the tension knob to
Bracket
level 16. Connect the cable to the ten-
sion cable located inside the console
E3000 ONLY
mast. Secure the tension knob to the
console mast with the washer (M5)
and screw (M5x70L). Tighten with
screwdriver.
• Slide the heart rate wires of the han-
dlebar through the hole in the handle-
bar bracket on the console mast.
Console
Secure the handlebar onto the
handlebar bracket with two screws
(M8x20L) and two lock washers (M8).
Tighten with the 5mm Allen wrench.
• Remove the four mounting screws from
the back of the console. Connect the
wire harness and the heart rate wires to
the console. Attach the console to the
console mast using the four mounting
screws that were just removed.
Waterbottle
Cage
• Attach the water bottle cage to the
console mast with two screws
(M5x15L) using the screwdriver. Insert
the water bottle into the cage.
E3100 ONLY
6