IMPORTANT: Never use the steamer without a cleaning pad attached to the floorhead. Never leave the steamer on one spot
for an extended period of time or with a damp or wet microfibre pad attached as this may damage the floor surface.
Using the steamer
Place the microfibre pad
on the floor, white side facing
up. Place steamer onto pad
making sure the entire pad
covers the floorhead.
Place your foot onto the
floorhead and pull handle
backwards to recline.
Plug into mains and twist
On/Off control dial to ON.
To produce steam squeeze
the trigger in short bursts.
Don't hold the trigger
continuously to prevent
over wetting floors.
Using your machine
The blue light will illuminate
to indicate power on. The
green light will illuminate
to indicate the steamer
is ready to use.
Move the steamer slowly
backwards and forwards
across the floor paying
particular attention to high
traffic areas. Squeeze
/release trigger as required.
Always switch OFF the
steamer when fitting the
microfibre cleaning pads.
CAUTION
To steam your floors with
detergent turn the dial to
ON and without detergent
turn the dial to OFF.
Hold corner of pad down
with your foot and lift
steamer to peel away.