Vax S86-SF-CC Let's Get Started page 10

Using your machine
IMPORTANT: When using on carpets, always make sure the microfibre cleaning pad is used and covers the floorhead
entirely before using the carpet glider.
Only use the carpet glider when refreshing carpets and turn the detergent dial to OFF.
Refreshing carpets
Place the microfibre pad on
the floor white side facing
up. Place steamer onto pad
making sure the entire pad
covers the floorhead.
Place your foot on floorhead
and pull handle backwards
to recline.
With microfibre pad attached,
push steamer into front
of the carpet glider, then place
back of the floorhead into
the clip. The carpet glider
should only be used when
refreshing carpets.
To produce steam squeeze
the trigger in short bursts.
Don't hold the trigger
continuously to prevent
over wetting carpet.
Plug into mains and twist On
/Off control dial to On.
Move the steamer slowly
backwards and forwards
across the carpet paying
particular attention to high
traffic areas. Squeeze/
release trigger as required.
Turn the detergent dial to OFF
when refreshing carpets.
To release the carpet
glider, place your foot on
clip and push down. Lift
steamer to remove.