Panasonic AJ-D440 Operating Instructions Manual page 31

Setup menus
USER menu
<BASIC>
No.
001
002
003
004
005
006
007
The underline on the setting item denotes the initial setting.
(continued)
Item Setting
Superimposed Superimposed
No.
display display
CHARA 0000
. .
H-POS
.
0005
. .
.
0012
CHARA
0000
. .
V-POS
.
0018
. .
.
0022
DISPLAY 0000
SEL 0001
0002 T&S&M
LOCAL 0000
ENA 0001
0002
TAPE 0000
TIMER 0001
SUPER 0000
0001
CHARA 0000
TYPE 0001 W/OUT
– 31 –
This sets the position of the characters on the horizontal
0
. .
plane for the time code and other super displays output to the
.
VIDEO OUT 3 connector.
5
. .
<Notes>
.
1. When setting this item, the DISPLAY SEL status is output
12
to VIDEO OUT 3 even if SUPER OFF has been set.
However, when the menu is exited, operation complies
with the SUPER OFF/ON setting.
Also, CHARA TYPE is output to VIDEO OUT 3 according
to the status set in the menu.
2. When the DISPLAY SEL setting causes characters to
extend beyond the edges of the screen, the setting value
is changed so that the characters are automatically
displayed in a position on the screen.
This sets the position of the characters on the vertical plane
0
. .
for the time code and other super displays output to the
.
VIDEO OUT 3 connector.
18
. .
<Notes>
.
1. When setting this item, the DISPLAY SEL status is output
22
to VIDEO OUT 3 even if SUPER OFF has been set.
However, when the menu is exited, operation complies
with the SUPER OFF/ON setting.
Also, CHARA TYPE is output to VIDEO OUT 3 according
to the status set in the menu.
2. When the DISPLAY SEL setting causes characters to
extend beyond the edges of the screen, the setting value
is changed so that the characters are automatically
displayed in a position on the screen.
TIME This selects what information is to be provided by the time code
and other super displays output to the VIDEO OUT 3 connector.
T&STA
0: Time only.
1: Time and status.
2: Time, status and mode.
<Notes>
•
When T&S&M has been selected, one of the following displays
appears on the third line of the superimposed display.
In the DVCPRO mode:
In the DV mode:
In the DVCAM mode:
•
An error message is displayed when an warning or error
occurs.
DIS This selects the buttons which can be operated on the front
panel when the REMOTE/LOCAL switch has been set to
ST&EJ
REMOTE.
ENA
0: No buttons can be operated.
1: Only the STOP and EJECT buttons can be operated.
2: All buttons can be operated.
12h This selects the 12 or 24 hour display for the CTL counter.
0: 12 hour display
24h
1: 24 hour display
This selects whether the time code and other super display
OFF
which are output to the VIDEO OUT 3 connector is to shown.
ON
0: Not shown.
1: Shown.
WHITE
This selects the display type for the super display output to
the VIDEO OUT 3 connector as well as for displays such as
the setting menu, etc.
0: White characters against a black background.
1: White characters with a black border.
Description
DVCPRO MODE
DV MODE
DVCAM MODE