Enable Clipaging - D-Link DGS-3000 Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
2-3 config serial_port
Description
This command is used to configure the serial bit rate used to communicate with the management
host and the idle connection auto logout time.
Format
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] | auto_logout [never |
2_minutes | 5_minutes | 10_minutes | 15_minutes]}
Parameters
baud_rate - (Optional) The serial bit rate that will be used to communicate with the management
host. The default baud rate is 115200.
9600 - Specify the serial bit rate to be 9600.
19200 - Specify the serial bit rate to be 19200.
38400 - Specify the serial bit rate to be 38400.
115200 - Specify the serial bit rate to be 115200.
auto_logout - (Optional) The auto logout time out setting.
never - Never timeout.
2_minutes - When idle over 2 minutes, the device will auto logout.
5_minutes - When idle over 5 minutes, the device will auto logout.
10_minutes - When idle over 10 minutes, the device will auto logout.
15_minutes - When idle over 15 minutes, the device will auto logout.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure baud rate:
DGS-3000-26TC:admin#config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DGS-3000-26TC:admin#
2-4

enable clipaging

Description
This command is used to enable the pausing of the screen display when the show command
output reaches the end of the page. The default setting is enabled.
Format
enable clipaging
10