D-Link DGS-3000 Reference Manual page 699

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3000-26TC:admin#config dscp trust 1-8 state enable
Command: config dscp trust 1-8 state enable
Success.
DGS-3000-26TC:admin#
69-14 config 802.1p map
Description
This command is used to configure the mapping of 802.1p to the packet's initial color. The
mapping of 802.1p to a color is used to determine the initial color of the packet when the policing
function of the packet is color aware and the packet is 1p-trusted.
Format
config 802.1p map {[<portlist> | all]} 1p_color <priority_list> to [green | red | yellow]
Parameters
<portlist> - (Optional) Enter the list of port used for this configuration.
all - (Optional) Specify that the command apply to all ports on the Switch.
1p_color - The list of source priority for imcoming packets.
<priority_list> - Enter the list of source priority for imcoming packets.
to - The mapped color for a packet.
green - Specify green as the mapped color.
red - Specify red as the mapped color.
yellow - Specify yellow as the mapped color.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
If a product supports per-port 802.1p mapping configuration, configure the mapping of 802.1p
priority 1 to red on ports 1-8.
DGS-3000-26TC:admin#config 802.1p map 1-8 1p_color 1 to red
Command: config 802.1p map 1-8 1p_color 1 to red
Success.
DGS-3000-26TC:admin#
69-15 show 802.1p map 1p_color
Description
This command is used to display the 802.1p to color mapping.
695