D-Link DGS-3000 Reference Manual page 594

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To disable MLD snooping multicast VLAN:
DGS-3000-26TC:admin#disable mld_snooping multicast_vlan
Command: disable mld_snooping multicast_vlan
Success.
DGS-3000-26TC:admin#
55-5 create igmp_snooping multicast_vlan
Description
This command is used to create a multicast VLAN and implements relevant parameters as
specified. More than one multicast VLANs can be configured. The maximum number of
configurable VLANs is 5.
Newly created IGMP snooping multicast VLANs must use a unique VLAN ID and name, i.e. they
cannot use the VLAN ID or name of any existing 802.1Q VLAN.
Also keep in mind the following conditions:
•
Multicast VLANs cannot be configured or displayed using 802.1Q VLAN commands.
•
An IP interface cannot be bound to a multicast VLAN.
•
The multicast VLAN snooping function co-exists with the 802.1Q VLAN snooping function.
Format
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority
[<value 0-7> | none] {replace_priority}}
Parameters
<vlan_name 32> - Enter the multicast VLAN here. The VLAN name can be up to 32 characters
long.
<vlanid 2-4094> - Enter the multicast VLAN ID to be created. This value must be between 2 and
4094.
remap_priority - (Optional) The remap priority (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN. If none is specified, the packet's original priority will be
used. The default setting is none.
<value 0-7> - Enter the remap priority value here. This value must be between 0 and 7.
none - Specify that the remap priority value will be set to none.
replace_priority - (Optional) Specify that packet's priority will be changed by the Switch, based
on the remap priority. This flag will only take effect when the remap priority is set.
590