Using Message Waiting/Callback - Panasonic Section750 User Manual

To use Automatic Camp-on (Call Waiting)
Note: Automatic Camp-on (Call Waiting) requires system programming.
1. Pick up the handset or press the ON/OFF key.
2. Dial the extension number. (The called party hears an alert tone and you hear
ringback tone.)
3. Remain on the line until the called party answers.
To leave a text message while camp-on
Press the MSG key
.
1.
2. Enter the send text message number (1-9, 0). (See Table 6 on page 57 for the send
text messages.)
To reply to a text message
Press the MSG key
.
1.
2. Enter the reply text message number (1-9, 0). (See Table 7 on page 58 for the text
message replies.)
To answer a Camp-on (Call Waiting) signal
1. Do one of the following:
To . . .
a. After receiving an alert tone, replace the handset or
Answer a call
press the ON/OFF key to end the first call.
b. Lift the handset or press the ON/OFF key again to
connect to the waiting call..
a. After receiving an alert tone, press the HOLD key to
Toggle between two calls (using
put the first call on hold.
Broker's Hold)
b. Press the ON/OFF key to pick up the second call.

USING MESSAGE WAITING/CALLBACK

You can leave a callback request message (or message waiting indication) for a busy
extension or one that does not answer. After sending the callback message, you hang
up the phone and wait for the call back. The called party's message indicator lamp
then flashes that a message has been received.
ICX-35-750 ICX (International), issued March 1999
5. Communicating Within Your Office
Do . . .
59