Switching Input Signal - ViewSonic LS810 User Manual

Switching input signal

The projector can be connected to multiple
devices at the same time. However, it can only
display one full screen at a time.
If you want the projector to automatically search
for various signals, please confirm that the
SYSTEM > Quick Auto Search function in the
Source menu is switched ON.
You may also press the source selection button
on the remote control or search for available input
signals to manually select the desired signals.
1. Press [Source] to display the source selection col-
umn.
2. Keep pressing the / until you arrive at the
desired signal, then press [Enter].
Once detected, the selected source information
will display on the screen for seconds. If there
are multiple devices connected to the projector,
repeat steps 1 to 2 to search for another signal.
For display resolutions of this projector, please refer to "Projector specifications".
To achieve the best image display effects, you should select and use an input signal that
outputs at this resolution. Any other resolutions will be scaled by the projector depending upon
the aspect ratio setting, which may cause some image distortion or loss of picture clarity. See
"Selecting the aspect ratio" for details.
23