Upload Of Address Translation Table - Panasonic KX-TDA0484 Programming Manual

2.4 Data Management
2.4.3

Upload of Address Translation Table

Before uploading the data, place the card in the "STOP" status (see "2.3.1 Status Control").
Click 3.3 Upload of DN2IP data (PC → VoIP Gateway) in the main menu.
1.
2.
Click Browse and choose a file to upload.
At any time during the session, you can:
• Click MENU to return to the main menu (see "2.1 Main Menu for the Administrator").
• Click LOGOUT to log out from the IP-GW4 Maintenance Utility (see "2.5.2 Log Out").
3.
Click UPLOAD (PC→VoIP Gateway).
The upload operation starts.
Notes
•
•
4.
Do one of the following:
• Click REBOOT to make the changes effective now.
You will see a confirmation screen. Refer to "2.5.1 Reboot" and finish the reboot.
• Click OK to return to the previous screen without rebooting.
48 Programming Guide
If the upload operation is executed while the card is in the "RUN" status, you will see an
error screen. Click Change RUN/STOP status Screen and place the card in the
"STOP" status (see "2.3.1 Status Control"), and then upload the data again.
If the operation is not successful for other reasons, you will see another error screen.
Click OK to return to the previous screen, and then upload the data again.