Table of Contents
Advertisement
4. Lay the motherboard in the node drawer aligning the standoffs with the
motherboard.
5. Secure the motherboard to the node drawer using the rounded, Phillips head
screws included for this purpose. Do not apply more than 8 inch-lbs. of torque
6. Install the adapter card associated with the motherboard. Refer to the next
section for instructions on installing the adapter card
7. Secure the CPUs, heatsinks, and other components to the motherboard as
described in the motherboard documentation.
8. Connect the cables between the motherboard, backplane, chassis, front
panel, and power supply, as needed. Also, fans may be temporarily removed
to allow access to the backplane ports.
9. Replace the riser card bracket and secure it with the screw.
10. Repeat for the remaining node.
Figure 6-12. Installing the Motherboard in the Node Drawer
Note: The node drawing is an example only; the actual layout differs slightly.
Chapter 6: Advanced Chassis Setup
6-11
Advertisement
Table of Contents
