Table of Contents
Advertisement
A+ SERVER 2122TC-DL6RF4 USER'S MANUAL
5-5
Installing Memory
Caution: Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
Installing Memory
1. Insert each memory module vertically into its slot, paying attention to the
notch along the bottom of the module to prevent inserting the module
incorrectly (see Figure 5-2).
2. Install to slots CPU1/DIMM1A, CPU1/DIMM2A, etc. Always install in groups
of two and in the numerical order of the DIMM slots. See support information
below.
3. Gently press down on the memory module until it snaps into place.
4. With two DIMMs installed, repeat step 2 to populate the CPU2 DIMM
slots. Always install two DIMMs to both CPU DIMM slots for more efficient
operation.
Note: 1 GB, 2 GB, 4 GB, 8 GB or 16 GB size memory modules are supported. It
is highly recommended that you remove the power cord from the system before
installing or changing memory modules. Please refer to our web site for memory
that has been tested on the 2122TC-DL6RF4 serverboard.
Memory Support
The H8DCT-HLN4F serverboard supports single and dual channel,
DDR3-1600/1333/1066 MHz speed registered ECC/Unbuffered ECC/non-ECC
SDRAM. Populating two slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory."
Maximum Memory
The H8DCT-HLN4F serverboard supports up to 192 GB of ECC RDIMM in
twelve (12) DIMM slots.
5-8
Advertisement
Table of Contents
