Table of Contents
Advertisement
TAD/FAX mode
(using the built-in answering device and receiving voice
and fax calls automatically)
When you turn on AUTO ANSWER (the pre-selected setting is TAD/FAX), the unit will work as a fax machine
and/or answering device.
If a fax call is detected, the unit will automatically switch to receive faxes.
If a voice call is detected, the answering device will begin recording and the caller can leave a voice message.
You can use a pre-recorded greeting message (see page 88) or record your own greeting message (see
page 89).
Setting up the voice message and document reception
The total recording time (including the greeting messages) is about 18 minutes. If messages are recorded in a
noisy room, the recording time may be shortened up to 11 minutes.
To set the unit to record incoming voice messages and receive fax documents, follow the steps below.
1
Select "TAD/FAX" in step 4 of feature setting #77
(see page 71).
2
If the AUTO ANSWER light is off, turn it on by
pressing
AUTO ANSWER
The unit will play the TAD/FAX greeting message
and the display will show the following message.
Display:
The remaining time for recording incoming
messages will be displayed.
Example:
Note:
Each incoming message recording time can be set to either 1 minute or unlimited. To change the setting, see
page 104.
When the remaining time is low, erase unnecessary messages from memory (see pages 92 and 98).
While an incoming call is being recorded, you can monitor it through the speaker. If this feature is not
required, set the ICM monitor feature to "OFF" (see page 105).
.
TAD/FAX MODE
TIME = 10m13s
AUTO ANSWER
TAD/FAX ON
ON
Setup
87
Advertisement
Table of Contents
