Related Manuals for DèLonghi SLF 605
Summary of Contents for DèLonghi SLF 605
- Page 1 D E’ LO N G H I C OO KIN G USER & INSTALLATION INSTRUCTIONS SL F 60 5 SL F 70 4 SL F 70 5 BUILT-IN COOKING HOB...
-
Page 3: Table Of Contents
CONTENTS Page Number Introduction ..........Important Safeguards &... -
Page 4: Introduction
Dear Customer, Thank you for purchasing the DeLonghi SLF 605, SLF 704, SLF 705 built-in cooking hob. The safety precautions and recommendations listed below are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance. -
Page 5: Important Safeguards & Recommendations
IMPORTANT SAFETY PRECAUTIONS AND RECOMMENDATIONS IMPORTANT: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. The appliance guarantee will be void if the appliance is used within a non domestic environment i.e. - Page 6 • Do not touch the appliance with wet or damp hands (or feet). • Do not use the appliance whilst in bare feet. • If you should decide not to use this appliance any longer (or decide to substitute another model), before disposing of it, it is recommended that it be made inoperative in an appropriate manner in accordance to health and environmental protection regulations, ensuring in particular that all potentially hazardous...
- Page 7 with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. • WARNING: Danger of fire: do not store items on the cooking surfaces. • WARNING: If the hob is cracked or otherwise damaged by falling objects etc., disconnect the appliance from the electrical power supply to avoid the possibility of electric shock and call Customer Service.
-
Page 8: Features And Technical Data
1 - FEATURES AND TECHNICAL DATA Mod: SLF 603 Fig. 1.1 Mod: SLF 704 Fig. 1.2 14 15 8 9 13 Mod: SLF 705 Fig. 1.3 10 13... - Page 9 GAS BURNERS Auxiliary (A) 1,00 kW Semirapid (SR) 1,75 kW Semirapid (SR) 1,75 kW Rapid (R) 3,00 kW Triple-ring compact (TRC) 3,50 kW Triple-ring (TR) 3,80 kW Dual (DB) (*) 4,20 kW IMPORTANT: The Dual burner (Model SLF 704) is controlled by two separate knobs;...
-
Page 10: How To Use The Cooktop
2 - HOW TO USE THE COOKTOP GAS BURNERS Gas flow to the burners is adjusted by turning the knobs (illustrated in fig. 2.1) which control the safety valves. Turning the knob, so that the indicator line points to the symbols printed on the panel, achieves the following functions: –... - Page 11 LIGHTING THE BURNERS DUAL BURNER - SOME MODELS ONLY ignite burner, following instructions are to be followed: The Dual Burner is a very flexible burner which allows different regulations and Press in the corresponding knob and optimal cooking. turn counter-clockwise (fig. 2.2) to the It is composed by one inner and one outer full flame position marked by the “...
- Page 12 CHOICE OF THE BURNER On the control panel, near every knob there is a diagram that indicates which burner is controlled by that knob. The suitable burner must be chosen according to the diameter and the capacity used. As an indication, the burners and the pots must be used in the following way: DIAMETERS OF PANS WHICH MAY BE USED ON THE BURNERS BURNERS MINIMUM...
- Page 13 SMALL PAN ADAPTER - SOME MODELS ONLY (OPTIONAL), fig. 2.4a This adapter is to be placed: • on top of the (smaller) auxiliary burner when using small diameter pans, in order to prevent them from tipping over; • on top of the Dual burner (used with the inner crown only) when using small diameter pans, in order to prevent them from tipping over.
- Page 14 WOK STAND (OPTIONAL) (figs. 2.5a - 2.5b, 2.6a - 2.6b, 2.7a - 2.7b) Only flat bottom pans of the correct size are to be placed on the pan support above the triple-ring compact, triple ring or dual burner (depending on models). When using a WOK, the supplied wok stand must be placed onto the pan stand to avoid any faulty operation of the triple-ring compact, triple ring or dual burner (depending on models).
- Page 15 MODELS WITH TRIPLE-RING BURNER WRONG CORRECT Fig. 2.6a Fig. 2.6b MODELS WITH DUAL BURNER CORRECT WRONG Fig. 2.7a Fig. 2.7b...
-
Page 16: Cleaning & Maintenance
3 - CLEANING AND MAINTENANCE GENERAL ADVICE CLEANING Before you begin cleaning, you • • Stainless steel hob: Spillage on must ensure that the appliance is the hob can usually be removed by switched off at the cooker switch. a damp soapy cloth. More obstinate stains can be removed by using a •... - Page 17 BURNERS These parts can be removed and cleaned with appropriate products. After cleaning, the burners and their flame spreaders must be well dried and correctly replaced. It is very important to check that the burner flame spreader and the cap have been correctly positioned.
- Page 18 Fig. 3.1 Fig. 3.2 MODELS WITH TRIPLE-RING MODELS WITH COMPACT BURNER TRIPLE-RING BURNER Fig. 3.3 Fig. 3.4...
- Page 19 MODELS WITH DUAL BURNER Fig. 3.5 Fig. 3.6 Fig. 3.7...
- Page 20 PAN SUPPORTS These parts can be removed and cleaned with appropriate products. After cleaning, they must be well dried and correctly replaced. It is very important to check that the pan supports have been correctly positioned. Failure to do so can cause serious problems. The prongs of the pan supports must always be centred with the burners (fig.
-
Page 21: Advice For The Installer
Advice for the installer... - Page 22 IMPORTANT : • The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi commercial or communal environment. Your product will not be guaranteed if installed in any of the above environments and could affect any third party or public liability insurances you may have.
-
Page 23: Installation
4 - INSTALLATION TECHNICAL INFORMATION FOR THE INSTALLER In order to install the cooker top into the kitchen fixture, a hole with the dimensions shown in fig. 4.1a has to be made, bearing in mind the following: ■ 60cm wide models: •... - Page 24 Fig. 4.1a The thermal protection barrier must • removable with the use of a tool for installation and service; • heat-resistant; • made from thermal Cooktop conductivity material. installed Thermal Clearance protection barrier Door Space for Fig. 4.1b Fig. 4.1c connections Measures (mm) Description...
- Page 25 FASTENING THE COOKTOP Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop to benches from 30 to 40mm thick. The kit includes two “F” type brackets (for the front of the cooktop), two “R” type brackets (for the rear of the cooktop) and four self-threading screws “S”.
-
Page 26: Provision For Ventilation
PROVISION FOR VENTILATION • The appliance should be installed into a room or space with an air supply in accordance with the current version of BS 5440-2: 2000. • For rooms with a volume of less than 5m - permanent ventilation of 100 cm free area must be provided. -
Page 27: Gas Installation
5 - GAS INSTALLATION GAS INSTALLATION REQUIREMENTS Important ! • Before installation, make sure that the local distribution conditions (gas type and pressure) and the adjustment of this appliance are compatible. The appliance adjustment conditions are given on the plate or the label. •... -
Page 28: Gas Installation
GAS CONNECTION Cat: 2H 3+ Installation to Natural Gas Installation to Natural Gas must conform to the Code of Practice, etc. The supply pressure for Natural Gas is 20 mbar. The installation must conform to the relevant British/European Standards. Installation to LP Gas When operating on Butane gas a supply pressure of 28-30 mbar is required. - Page 29 The fitting (fig. 5.1) is made up of: 1/2" BSPP (G) parallel 1/2" BSPP (G) parallel – 1 nut “A” (ISO 228-1) male (ISO 228-1) female – 1 elbow fitting “C” – gasket “F” Connection to the Gas Supply – Be careful when flexible pipes are used that they do not come into contact with moving parts.
- Page 30 GAS MAINTENANCE TABLE FOR THE CHOICE OF THE INJECTORS G30/G31 Cat:II 2H 3+ 28-30/37 mbar 20 mbar Nominal Reduced Ø injector Ø injector BURNERS Power Power [1/100 mm] [1/100 mm] [kW] [kW] Auxiliary (A) 1,00 0,40 Semi-rapid (SR) 1,75 0,45 Rapid (R) 3,00 0,75...
- Page 31 REPLACEMENT OF THE INJECTORS Auxiliary, If the injectors are not supplied they can semi-rapid be obtained from the “Service Centre”. and rapid burner Select the injectors to be replaced according to the “TABLE FOR THE CHOICE OF THE INJECTORS”. nozzle diameters, expressed hundredths of a millimeter, are marked on...
- Page 32 SETTING THE MINIMUM OF THE COOKTOP BURNERS In the minimum position the flame must have a length of about 4 mm and must remain lit even with a quick turn from the maximum position to that of minimum. The flame adjustment is done in the following way: •...
-
Page 33: Electrical Installation
6 - ELECTRICAL INSTALLATION IMPORTANT: The appliance must be installed in accordance with the manufacturer’s instructions. Incorrect installation, for which the manufacturer accepts no responsibility, may cause damage to persons, animals or property. The connection of the appliance to earth is mandatory. The manufacturer declines all responsibility for any inconvenience resulting from the inobservance of this condition. - Page 34 ELECTRICAL FEEDER CABLE REPLACEMENT WARNING: If the power supply cable is damaged, it must be replaced only by an authorized service agent in order to avoid a hazard. To connect the supply cable: • Unhook the terminal board cover by inserting a screwdriver into the two hooks “A” (fig. 6.2).
-
Page 35: Guarantee & After Sales Service
7 - GUARANTEE Your new “De’Longhi” product comes with 12-month guarantee covering all parts and labour. If your appliance proves to be defective as a result of faulty materials or workmanship during the guarantee period, these parts will be repaired or replaced free of charge. AFTER SALES SERVICE Should you require service, spares or product information and advice: •... - Page 36 D esc ri pt i o n s an d i ll ustrations i n this book let are gi ven a s s im p ly i nd ica ti ve . T he m an u f a c t u r er re serves the right, considering th e cha r acte ri sti cs o f the model s de sc r ib ed he re, at any tim e and w ithout noti ce, to m a ke ev entu a l neces sa r y modifi c at i o n s f o r t he i r construction or for co mm erci al n eed s.