Related Manuals for DèLonghi GHS 261 ST
Summary of Contents for DèLonghi GHS 261 ST
- Page 1 Users Operating Instructions Before operating this hob, please read these instructions carefully GHS 261 ST gas hob...
- Page 2 Dear Customer Thank you for choosing one of our appliances which has been carefully designed and built by our specialist staff and thoroughly tested to satisfy your cooking requirement. We suggest that you read this Instruction Booklet so that you will understand fully how to operate the appliances.
-
Page 3: Tips For The User
IMPORTANT WARNINGS AND TIPS When unpacking the appliance make sure that it is not damaged. If you have any doubts, do not use the appliance but consult your supplier or an engineer. The packing materials (plastic bags, expanded polystyrene, nails, bands etc.) must not be left within easy reach of children, as these may result in serious injury. -
Page 4: How To Use Your Gas Hob
How to use your gas hob Figure 1 This appliance is class 3 COOKING POINTS 1. Auxiliary burner (A) - 1,00 kW 2. Right medium-speed burner (SR) - 1,75 kW 3. Left medium-speed burner (SR) - 1,75 kW 4. Rapid burner (R) - 3,00 kW CONTROL PANEL 5. -
Page 5: Gas Burners
GAS BURNERS Gas flow to the burners is adjusted by turning the knob illustrated in fig. 2 which con- trols the safety valves. Turning the knob so that the indicator line points to the symbols printed on the panel achieves the following functions: full circle closed valve symbol... -
Page 6: Lighting Of Burners
LIGHTING OF BURNERS To ignite the burners follow these instructions: – Lightly press the knob (fig. 3) in an anti-clockwise direction up to the maximum aperture (symbol ); press the knob right down to prime the electric ignition until the burner lights. In case of power cut manually light the burner. -
Page 7: Choice Of Burner
CHOICE OF BURNER The burner must be choosen according to the diameter of the pans and energy required. Attention: During use the hob becomes very hot under the cooking zones. Keep children away. PAN DIAMETER Figure 4 BURNER MINIMUM MAX. Auxiliary 6 cm 14 cm... -
Page 8: Cleaning And Maintenance
Cleaning and Maintenance GENERAL TIPS Before cleaning the hob switch it off and wait for it to cool down. Clean with a cloth, hot water and soap or liquid detergent. Do not use products which are abrasive, corrosive or chlorine based. Do not use steel pads. -
Page 9: Correct Positioning Of The Burners
CORRECT POSITIONING OF THE BURNERS It is very important to check that spreader F and cap C of the burner (see Figures 5 and 6) are perfectly in place because if they move out of place serious problems could arise. Make sure that electrode "S"... -
Page 10: Important Notes
Important notes Installation, and any demonstration, information or adjustments are not included in the warranty and, if requested, the customer must pay the after-sale service according to the standard fees. BEFORE CALLING FOR ASSISTANCE If any burner does not light, check the ignition is working, if not check the 3 amp fuse, make sure gas is turned on make sure burner caps are in Position correctly. -
Page 11: Do's And Do Not's
Do’ s and do not’ s DO’S AND DO NOT’S • Do read the User Instructions carefully before using the hob for the first time. • Do remove spills as soon as they occur. • Do not allow children near the hob when in use. •... -
Page 12: Installation
Installation IMPORTANT The hob should only be installed by a C.O.R.G.I. registered installer. Failure to observe this rule leads to cancellation of the guarantee. The appliance must be installed correctly, in compliance with the regulations in force and following the manufacturer's instructions. Any repair or maintenance must be performed with the appliance switched off. - Page 13 To fit the hob into the unit make an opening of the dimensions given in Figure 7, remembering that: Inside the unit there must be a space of at least 30 mm between the bottom of the hob and the top of a shelf. Any wall to the side and above the hob must be at least 100 mm away (Fig.
-
Page 14: Fastening The Hob
INSTALLATION ABOVE UNITS WITH DOORS (fig. 9) The unit must be so constructed that the movement of air caused by closing and open- ing, even violent, of the doors does not cause the burners to go out. Leave a depression space of 30 mm between the bottom of the hob and the top of the unit (Fig. - Page 15 Ventilation All rooms require an openable window or equivalent, while some rooms require a perma- nent vent in addition to a window that can be opened. This unit must not be used in a room with less than 6 m room volume air vent necessary (effective area) to 9 m...
-
Page 16: Gas Section
Gas Section IMPORTANT NOTE This appliance is supplied for use on NATURAL GAS only and cannot be used on any other gas without modification. This appliance is manufactured for conversion to LPG. To purchase an LPG conversion kit telephone accessories direct 0870 6052020. The gas hob must be installed by a qualified person in accordance with the Gas Safety (Installation and Use) (Amendment) Regulation 1990 and the relevant Building / I.E.E. -
Page 17: Gas Connection
GAS CONNECTION The installation of the hob to Natural Gas or LP Gas must be carried out by a C.O.R.G.I. registered installer. Installer shall take due account of the provisions of the relevant British Standards Code of Practice, the Gas Safety Regulations and the Building Standards (Scotland) (Consolidation) Regulations issued by the Scottish Development Department. -
Page 18: Conversion To Lpg
Conversion to LPG 1 - INJECTORS REPLACEMENT This appliance is manufactured for conversion to LPG. To purchase an LPG conversion kit telephone accessories direct 0870 6052020. To replace the injectors proceed as follows: – Remove pan-supports and burners from the hobtop. –... - Page 19 TABLE FOR THE CHOICE OF THE INJECTORS NOMINAL REDUCED G30/G31 G 20 Cat: 2H3+ POWER POWER 28-30/37 mbar 20 mbar Ø injector Ø injector BURNER [Hs - kW] [Hs - kW] [1/100 mm] [1/100 mm] Auxiliary (A) 1,00 0,30 72 (X) Semi-rapid (SR) 1,75 0,45...
-
Page 20: Minimum Burner Setting Adjustment
2 - MINIMUM BURNER SETTING ADJUSTMENT Check whether the flame spreads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some ports do not light, increase the minimum gas rate setting. Check whether the burner remains lit even when the gas tap is turned quickly from the maximum to the minimum position. -
Page 21: Electrical Connection
Electrical Connection For your safety please read the following information Warning: This appliance must be earthed. The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three pin socket, suitably earthed and should be protected by a 3 amp fuse in the plug. - Page 22 Descriptions and illustrations in this booklet are given as simply indicative. The manufacturer reserves the right, considering the characteristics of the models described here, at any time and without notice, to make eventual necessary modifications for their construction or for commercial needs.
- Page 24 cod. 1102433 ß3...