Wall Mounting - Panasonic KX-HDV100 Operating Instructions Manual

R Use a straight CAT 5e (or higher) Ethernet cable (not included) that is 6.5 mm (1/4 in) in diameter or
less.
When connecting cables and the AC adaptor
R Pass the Ethernet cable and the AC adaptor cord under the stand.

Wall Mounting

Note
R Make sure that the wall and the fixing method are strong enough to support the weight of the unit.
1. Insert the tabs of the wall mounting adaptor into the designated openings in the base, and then slide
the wall mounting adaptor in the direction of the arrow until it clicks.
2. Fasten the wall mounting adaptor to the base with the small screw.
(Recommended torque: 0.4 N·m [4.08 kgf·cm/3.54 lbf·in] to 0.6 N·m [6.12 kgf·cm/5.31 lbf·in])
3. Connect the AC adaptor and handset cord.
4. Drive the large screws into the wall either 83 mm (3 1/4 in) or 100 mm (3 15/16 in) apart, and mount
the unit on the wall.
*1
*1 40 mm (1 37/64 in) or less
*2 AC adaptor
*3 Ethernet cable
*4 Washer
*5 Drive the screw to this point.
*6 83 mm (3 1/4 in)
*7 100 mm (3 15/16 in)
R You can find a wall mounting template at the end of this manual.
R When inserting screws, avoid pipes and electrical cables, etc., that may be present/buried.
R The screw heads should not be flush to the wall.
R Certain types of wall may require plugs to be anchored in the wall before the screws are inserted.
2
*2
*3
Installation and Setup
4
*4
*5
*6
*7
41