Blockages
xx XXL
The status display shows the number of
cutting blade blockages that have
occurred since the counter was last set
to "0" – "RESET".
This can be used to determined whether
the diameter of the wood cut
corresponds to the capacity of the tool
and whether the tool is being operated
properly.
Menu commands:
PUSH 2 sec.
→
PGND
↓
↑
Adjusting cutting blade opening angle
The controller is set at the factory so that
the cutting blade only opens halfway
(50%) when the trigger is pulled twice in
quick succession.
To re-open the cutting blade fully, pull
the trigger again twice in quick
succession.
1/2
50%
PUSH
↓
1/2
60%
PUSH
↓
1/2
70%
PUSH
↓
1/2
PUSH
↓
ASA 85
The four values shown enable the
cutting blade opening angle to be set
(50%, 60% or 70%) or the option to be
deactivated.
Menu commands:
PUSH
PGND
Standby mode
The cutting blade can be set to the
constantly closed position for the
standby mode.
RESET
Pull the trigger twice in quick
N
succession and hold it there until 3
quick beeps sound.
PGUP
Release the trigger – the cutting blade
remains closed. To re-open the cutting
blade:
Pull the trigger again.
N
CLICK - CLICK
CLICK - CLICK
This option can be deactivated by
ON
pushing the control lever – "PUSH".
Menu commands:
PUSH
ON
PGND
ON
Adjust cutting action of blade
(proportional cut / impulse cut)
The pruning shears are set at the factory
so that the closing motion of the cutting
OFF
blade is proportional to the movement of
the trigger.
PUSH
→
PGUP
↓
↑
ON
PUSH
↓
OFF
PUSH
→
PGUP
↓
↑
This function can be deactivated so that
the cutting blade closes fully when the
trigger is operated (impulse cut).
REG
PUSH
↓
REG
This setting is automatically reset when
the cordless pruning shears are
switched off.
Menu commands:
PGND
↓
↑
English
ON
OFF
PGUP
15