Rinnai 314 Customer's Operating Information And Installation Instructions page 8

room size: This heater must not be installed in a room smaller then 30 m3.
Check
Your Convector
fitting, simply plug into your bayonet floor fitting.
Plug the heater into both the gas and
the power points. Room must be
ventilated when using this heater.
Depress the ignition button slowly and
firmly.
When you release the ignition button
the 'Temperature Level' lamps will
illuminate, the spark will ignite the
main burner and the convection fan
will begin to run. If the unit does not
ignite in 15 seconds the spark will
stop and the display will flash. Turn
off and repeat ignition operation.
(See page 7).
This heater has an automatic ignition
system, when the main burner has lit,
the combustion indicator will glow, and
the spark will stop.
There may be a smell of burning dust
the first time the heater is lit or when
the heater has been out of operation
for a long time, this is normal. You
may need to repeat the ignition
operation the first time the heater is
plugged in, due to air in the hose.
CUSTOMERS OPERATING
INFORMATION
INSTALLATION
is fitted with a flexible lead and bayonet type plug in
314
IGNITION
PUSH
Temperature Level
ROOM TEMP
(Flashing)
Combustion Indicator
ON OFF
SET TEMP
(Steady)