Table of Contents
Advertisement
Before playback
Auto speaker setup
AUTO
SPEAKER SETUP
[
]
While performing auto speaker setup, errors may occur and the messages will blink or scroll on the display, depending on the
conditions. Press any button on the main unit or remote control to stop the setup.
After troubleshooting, press and hold
Troubleshooting for auto speaker setup
Message
"INSERT MIC"
"NO SIGNAL"
"DISTANCE ERROR"
"NOISY"
"MEASURING ERROR"
"CHECK CONNECTION
TO SBL SPEAKER"
"NEED TO CONNECT
LS/RS SPEAKERS"
"CHECK
CONNECTIONS TO
LS/RS SPEAKERS"
"CHECK
CONNECTIONS TO L/R
SPEAKERS"
"LOW SIGNAL"
Note
•
Auto speaker setup may produce an unsatisfactory result with some speaker setups and configurations.
•
You can perform auto speaker setup even if SPEAKERS A are off.
•
For subwoofer, only level is adjusted in auto speaker setup.
•
All settings in auto speaker setup return to the factory setting if you do automatic speaker detection (
change the speaker size (except for front speakers) from "NO" or "NONE" to other size settings ("Speaker and size settings",
page 27).
➡
•
Auto speaker setup will not start if you have muted the speakers. Turn the muting off (
RQTV0247
•
VIERA Link "HDAVI Control
16
SPEAKERS
A
AUTO DETECTOR
AUTO
ADVANCED
SPEAKER SETUP
DUAL AMP BI-AMP
SPEAKERS
TUNE
A
B
SURROUND
AUTO DETECTOR
AUX
SETUP MIC
S VIDEO IN VIDEO IN L
R
AUTO
for 2 seconds to start the setup process again.
TEST
•
Calibration microphone is not detected. Insert the microphone correctly.
•
Check that the calibration microphone is connected correctly.
•
Bring the speakers nearer to the calibration microphone.
•
Setup in a quiet environment or do auto speaker setup at a quieter time of day.
•
Turn off equipment that may produce noise, such as air conditioners.
•
Change the positions of the speakers and perform the setup again.
•
Left surround back speaker not detected. If you have decided to use only one
surround back speaker, connect it to the SURROUND BACK (L) terminal.
•
Check connection to left surround back speaker.
•
Surround speakers not detected. You must have surround speakers connected
before you can connect and use surround back speakers effectively.
•
One or both surround speakers not detected. Check the connections.
•
Check the front (L) and (R) connections.
•
Change the position (height and direction) of the microphone.
•
Make sure there is nothing around the microphone that could interfere with the test
tones.
•
Make sure the volume of the subwoofer is set to the level you would normally use.
TM
" (
page 21) is disabled during auto speaker setup.
➡
B
HDMI
VOLUME
INPUT SELECTOR
MENU
SETUP
ENTER
RETURN
Solutions
➡
RECEIVER
AV
SYSTEM
RECORDER
TV
DVD
TUNER
PLAYER
CD
VCR
BD/DVD
BAND
ANALOG 6CH
CH
VOLUME
0
DIRECT
TUNING
DISC
-/--
SKIP
SLOW/SEARCH
STOP
PAUSE
PLAY
DRIVE SELECT
MANUAL SKIP
ENTER
SUB MENU
RETURN
SUBWOOFER
TV
OFF
DIMMER
EFFECT VOL
LEVEL
NEO:6
TV/AV
SFC
AUTO
MUSIC
MOVIE
TEST
MUTING
page 17) separately, or,
➡
page 31).
Pages
14
14
-
-
-
-
13
13
13
13
13
-
-
17
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
