Table of Contents
Advertisement
Installation of ATAPI/E-IDE Drives
Installing the DVD Drives
This chapter explains how to physically install your drive in your computer. The steps you need to
perform are as follows:
1.
Turn off your computer system and unplug it from the power outlet.
2.
Remove the computer cover.
3.
Set the Master/Slave jumper on the rear panel of the drive, following the instructions below.
NOTE: To get the best results from your hard disk drive and your drive, we recommend that you connect
the drive to the secondary IDE port as the Master device, as described below.
7
Advertisement
Table of Contents
