Error Messages; Troubleshooting - Panasonic KXTGC212FX Operating Instructions Manual

Useful Information
Cyrillic character table (
z 1 2

Error messages

Display message
Base no power
or
No link. Reconnect
AC adaptor.
Check Phone Line
Memory Full
Use rechargeable
battery.
You must first
subscribe to Caller
ID.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor and turn off the handset, then reconnect the base unit's AC adaptor and turn on the
handset.
General use
Problem
The handset does not turn
on even after installing
charged batteries.
30
TGC210_212FX_(en-en)_0410_ver.031.pdf
)
3 4 5 6
Cause/solution
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset's registration may have been cancelled.
Re-register the handset (page 33).
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
R The phonebook memory is full. Erase unwanted entries
(page 17).
R The call block list memory is full. Erase unwanted entries
(page 24).
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 3, 6.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Cause/solution
R Place the handset on the base unit or charger to turn on the
handset.
30
7 8 9 y
2014/04/10 16:35:47