Flue Manifold Position; Wall Mounting Brackets - Rinnai RHFE-556FTD How To Use Manual

LOCATION
Do not install the heater in an unusually dusty
area.
X
Use a flue guard if the terminal is easily
accessible to children.
Check local regulations.
Guards are available as an optional extra.
Guard
Floor must be level.
Do not use electrical extension cords to connect
unit to power supply.
Keep the power cord away from the flue.
FLUE MANIFOLD POSITION.
FOR WEATHERBOARD WALLS DRILL
THROUGH CENTRE OF WEATHER BOARD
FROM OUTSIDE, THEN DRILL FROM INSIDE
THROUGH PLASTERBOARD.
Flue Hole
Cavity Openmg
i
280/
/
Before drilling the flue hole, check for water and
gas pipes as well as electric cables.
Use an 80 mm (8 cm) drill for hole through wall.
WALL MOUNTING BRACKETS
Place top back spacer in position. Mark the position
of the top edge of the top spacer on the wall. Move
the heater away from the wall. Mark centre lines
80 mm down from the top edge mark, and 40 mm in
front the left and right hand sides of the top spacer.
Attach wall brackets at the marked position.
Remove right hand back cover.
Centre of hole for flue manifold can be drilled
anywhere within the shaded area. (To avoid
studs etc.)
-18-