Sleeve And Manifold Installation - Rinnai rhfe-551ft Installation Insrtuctions

SLEEVE AND MANIFOLD INSTALLATION
METHOD FOR STANDARD WALLS
1. D&assemble Manifold from Sleeve
The flue consists of 3 parts, sleeve,
inside connectors and tube, outside
terminal (dis-assemble by pulling hard
on outside terminal and inner connec-
tions, then pull sleeve off outer
terminal).
Connections
2. Adjustment of Sleeve Length
Measure wall thickness through previ-
ously drilled 80 mm hole (see P14).
End of sleeve should protrude S-10 mm
from outside wall. Adjust sleeve length
to wall thickness plus 5-10 mm. (Sleeve
is threaded for adjustment.)
Extension joint
3. Depending on flue set and wall thick-
ness extension piece "C" may need to
be removed.
Cut plastic, remove extension, then
follow instruction 2.
"A" Flue ONLY
This applies to "A" flues only. There is
no extension on "B" and "C" flues.
"B" and "C" flues can be fully adjusted
by turning the threaded section.
\
Remove extension at this
point if necessary.
4. Fixing Sleeve
Fix ,$o inside wall, use 3 screws pro-
vided.
NOTE:-
Flange is marked "TOP" sleeve must be
fitted with this mark UP.
Check sleeve protrudes 5-10 mm on
outside.
Don't
remove green plastic covering
from sleeve.
- 15 -