Mounting The Transport Guard - Stihl FS 260 R Instruction Manual

Other Hints on Starting
At very low outside temperatures
Set the engine to winter operation if
N
necessary, see "Winter Operation".
If your machine is very cold (frost or
N
ice on machine), start the engine
and keep it at a high idle speed
(cutting attachment rotates) until it
reaches normal operating
temperature.
Engine stalls in cold start position g or
under acceleration
Move the choke lever to < and
N
continue cranking until the engine
runs.
Engine does not start in hot start
position <
Move the choke lever to g and
N
continue cranking until the engine
runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Engine is flooded
Move the choke lever to < and
N
continue cranking until the engine
runs.
FS 240, FS 240 C, FS 240 R, FS 240 RC, FS 260 R, FS 260 RC
Fuel tank run until completely dry
Recommendation: Carry out the
following steps irrespective of the
engine's operating condition before the
tank was run dry.
Set the choke lever to g.
N
Go to section on "Starting the
N
Engine" and re-start the engine as
described for a cold engine.
Mounting the Transport
Guard
Using Transport Guard
The type of transport guard depends on
the metal cutting attachment supplied
with the machine. Transport guards are
available as special accessories.
230 mm Grass Cutting Blades
English
29