Setting Procedures - Panasonic WV-CW480S Operating Instructions Manual

Setting Procedures

First, select a language for menu display and camera ID display.
Language Setup (LANGUAGE
SETUP)
1. Select LANGUAGE on the top menu and
press the [SET] button.
→ The LANGUAGE SETUP menu opens.
2. Select a language. The default setting is
English.
Available languages: ENGLISH, FRANÇAIS,
ESPAÑOL, DEUTSCH, ITALIANO, êìëëäàâ, CHINESE, JAPANESE
3. Select SET on the menu and press the [SET] button.
1. Camera Identification Setting (CAMERA ID)
Assign a name to the camera using up to 16 characters to display it overlaying on the camera
picture in the selected position.
Note: If you change the language selection after
the assignment of camera ID, it will be
erased.
1. On the CAMERA SETUP menu, select ON↓ or
OFF↓ for CAMERA ID and press the [SET]
button.
ON↓: Displays entered camera ID.
OFF↓: Does not display the ID.
→ The CAMERA ID menu opens.
2. Select a character from the character area
and press the [SET] button.
→ The selected characters are displayed in
the editing area.
3. Repeat these procedures until all characters
are entered.
• To enter a blank space, select SPACE and
press the [SET] button.
• To replace a specific character in the editing
area:
1. Move the cursor to the editing area and
then move the pointer to the character to
be replaced pressing the [LEFT] and
[RIGHT] buttons.
2. Move the cursor to a candidate character
in the character area and press the [SET]
button.
**LANGUAGE SETUP**
LANGUAGE ENGLISH
SET
RET TOP END
**CAMERA SETUP** 1/2
CAMERA ID OFF
ALC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
DNR HIGH
RESOLUTION HIGH
BW MODE
CAMERA ID
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$
SPACE POSI
RET TOP END RESET
................
Character
Cursor
Character
Area
Command
Editing
Area
Pointer
Highlighted
29