Table of Contents
Advertisement
Information on the display panel
Display
The door cannot be
locked, please open
the door again, then
close it and select
"start/pause".
Please open tap
Please clean pump
Pause: Reload is not
possible
Door cannot be
unlocked: Water
level or temperature
is too high
aquaStop has been
activated!
Please call customer
service
Auto power-off in ...
seconds,
Water cooling
Other displays
Error E: XXX
40
Cause/Remedy
– Washing may be caught. Please open and close washing
machine door again and select inicio/pausa carga
Pause).
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
– Turn on tap fully.
– Supply hose kinked/jammed.
– Water pressure too low. Clean the filter.
– Drain pump blocked. Clean the drain pump.
– The water drainage pipe/drain hose is blocked. Clean the
drainage hose on the siphon.
Water level or temperature is too high.
Select inicio/pausa carga
programme.
Water level or temperature is too high.
Select inicio/pausa carga
programme.
not applicable without Aqua-Stop
Water in the base pan, appliance leaking.
Call customer service!
Appliance automatically switches off after ... seconds if it is not
operated for a prolonged period. In order to cancel the
programme, press any button.
To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service.
Page 37
(Start/Pause) to continue the
(Start/Pause) to continue the
Page 43
Page 32
(Start/
Page 38
Page 36
Page 43
Advertisement
Table of Contents
