Using Your Cd/Mp3 Player; Goal Center; Goal Center Setup; Viewing Goal Progress - Horizon Fitness endurance 3 Owner's Manual

USING yoUR CD / MP3 PLAyER
1) Connect the included AUdIO AdAPTOR CABLE to the AUdIO IN jACK on the top
right of the console and the headphone jack on your Cd / MP3 player.
2) Use your Cd / MP3 player buttons to adjust song settings.
3) Remove the AUdIO AdAPTOR CABLE when not in use.
GoAL CENTER ™
Research shows that those who create and track their fitness goals, on average, achieve greater success than those who do not.
Because your new elliptical is equipped with Horizon's exclusive gOAL CENTER Performance Tracker, you've taken an important
step towards achieving your fitness goals. gOAL CENTER is innovative new software, integrated into your console, that will allow
you to track your fitness goals over time, without the need for paper journals or logs.
GoAL CENTER™ SETUP
1) Select USER 1 or USER 2.
2) Press and hold the gOAL CENTER button for approximately five seconds.
3) Select a time, distance or calorie goal using
4) Use to select a goal value. Press ENTER.
5) Use to select the NUMBER OF dAYS to complete the goal.
6) Press ENTER again to exit gOAL CENTER setup.
NOTE: These steps can also be used to erase an existing goal and set a new one.
24
. Press ENTER.
HoW To SAVE WoRKoUT DATA To GoAL CENTER
At the end of your workout, the console will save your workout data towards your goal.
VIEWING GoAL PRoGRESS
At any time during or before a workout, you can view your progress towards your goal by pressing the gOAL CENTER button. Use
to select USER 1 or USER 2 and press ENTER. The console will scroll the remaining time, distance or calories, depending on the goal
you set previously and will also scroll the time remaining to achieve your goal.
ENERGy SAVER (STANDBy MoDE)
This elliptical has an energy saver mode. The display will automatically enter standby mode (energy saver mode) after 15
minutes of inactivity. Almost all power for the elliptical will be off except for some circuits that are needed to detect a key press
or RPM detection, indicating the console should "wake up".
25