Installing The Rackswitch In An Ibm Idataplex Rack - IBM RackSwitch G8264CS Installation Manual

Installing the RackSwitch in an IBM iDataPlex rack

This section describes how to install the RackSwitch in an IBM iDataPlex rack. The
IBM iDataPlex mounting kit allows the switch to be mounted either vertically or
horizontally. For information about mounting the switch in other rack types, see the
following sections:
v "Installing the RackSwitch in a standard equipment rack" on page 19
v "Installing the RackSwitch in an IBM System x or Power rack" on page 25
The iDataPlex rack mount kit must be purchased separately.
The following table lists the parts included in the iDataPlex mounting kit.
Attention:
networking switch with only the front post mounting brackets (2-post application). If
the switch has an undesirable amount of sag, it is recommended to use a 4-post
mounting kit.
Attention:
DANGER
(L002)
To install the RackSwitch in an iDataPlex rack, complete the following steps:
1. Locate and record the product switch information to configure and register your
22
IBM System Networking RackSwitch G8264CS: Installation Guide
Table 13. iDataPlex rack mount kit parts
Item number
1
2
3
4
5
6
7
8
The rack-mounting frame may not be able to support the weight of the
For earthquake stability, mount the switch in a 4-post rack.
Rack-mounted devices are not to be used as shelves or work spaces.
product and set aside. See "Before installing the RackSwitch" on page 15.
Description
Label
M6 locking washers
M6 screws
M6 clip nuts
M4 screws
Switch front bracket
Switch rear bracket
Rear mounting bracket
Quantity
1
8
8
8
16
2
2
2