Installing The Switch; Installing The Switch In A 4-Post Rack - IBM SAN48C-6 Installation, Service And User Manual

Figure 9. NEBS Kit for 4-Post Installation
1 NEBS air baffle
2 NEBS rack-mount brackets
For more information on how to install the switch, see the Installing the Switch in a 4-Post Rack and
Installing the Switch in a 2-Post Rack.

Installing the Switch

This section describes how to use the rack mount kit to install the IBM SAN48C-6 switch into a cabinet or
rack that meets the requirements described in the Cabinet and Rack Requirements section.

Installing the Switch in a 4-Post Rack

Before you begin
• Inspect the switch shipment to ensure that you have everything you ordered.
• Make sure that the switch rack-mount kit includes the following parts:
– Rack-mount brackets (2)
– Rack-mount guides (2)
– Slider rails (2)
– M4 x 0.7 x 8-mm Phillips countersink screws (12)
• Make sure that the rack is installed and secured to its location.
3 notch
4 slot
Chapter 3. Installing the IBM SAN48C-6 Switch 17