Rinnai rhfe-431ft Instruction Manual page 26

5. Check rubber seal is in place on terminal.
l
For weather board walls, add spare
rubber seal provided to compensate for
weatherboard angle.
6.
Installation of Terminal
From outside, insert terminal into sleeve
with the "A" mark at the top. Left hand
side fixing tie is marked "LEFT" (from
inside).
7. Attaching Ties
Pull hard on left and right hand side ties,
clip ties over lugs inside sleeve. You
should be able to pull ties 2 or 3 slots
past the starting point. Cut the ties,
leaving about 20 mm past the lugs. Bend
ties so they are parallel with the wall.
8.
Insert Inner Connection Assembly. Push
assembly into the terminal tube, make
sure "TOP" mark is uppermost. Fix with 3
screws provided.
9.
Manifold can still be turned after
attaching.
Terminal seal
(Add "weather board.
Cut (leave 20 mm free)
Sleeve Terminal
1, Top Mark
inlet
-26-