Bridge Mode Hi-Z (140Vrms/200Vrms) - Crown DCi 8 600DA Operation Manual

Hide thumbs

Table Of Contents

Table of Contents

Application Examples

Bridge Mode Hi-Z (140Vrms/200Vrms)

Typical input and output wiring, along with software

settings are shown in Figure 27 and Figure 28.

INPUTS: Connect the input to the odd-numbered

channels (1,3,5,7) only. Even-numbered inputs are

disabled when the Bridge Mono mode is active.

OUTPUTS: Connect the speaker across the positive

terminals of each channel pair. Do not use the

negative terminals of the channel pair when the pair

is being operated in Bridge Mono mode.

NOTE: For global selection of 70Vrms (140Vrms

bridged) or 100Vrms (200Vrms bridged) operation,

refer to "Hi-Z/Low-Z" on page 15.

DANTE: When connecting via Dante, two Dante-

equipped devices can be connected directly together

using the Primary Dante ports. If connecting more

than two Dante devices, the Primary ports of each device should be connected to a network switch (this is a referred to as a "star" network topology).

100Mbps network switches and Category 5 cabling can be used for smaller Dante networks where smaller channel counts and/or lower sample rates are used. For optimum

performance and improved reliability, a Gigabit network and Category 5e or Category 6 cabling should be used. Visit the Audinate website for more information.

To provide fault protection when using Dante, connect the Secondary ports of all Dante devices to a secondary (separate) network switch. If any "primary" cable connections

or the "primary" switch fail, the "secondary" Dante network will automatically take over.

For further information on Dante, refer to "Dante" on page 28.

NOTE: Always route the input and output wires in separate bundles.

WARNING: Only connect to networks that remain inside the building.

DriveCore Install DA Series Operation Manual

RESET

SERIAL NUMBER

BAR CODE

100 – 240V

50/60 Hz 1400W

CAUTION - TO REDUCE THE RISK OF ELECTRIC

SHOCK, GROUNDING OF THE CENTER PIN