Installation
Pre-Installation Requirements
The following tools and equipment are required for installation of an Alcatel-Lucent 4306 switch.
AC Power Cord (country-specific)
Physical Installation
Tabletop Deployment
To deploy an Alcatel-Lucent 4306 switch on a flat surface, such as a tabletop:
1. Insert the four rubber mounting feet to the bottom of the unit.
2. Place the unit on a hard flat surface.
Initial Setup and Network Connectivity
Once the physical installation is complete, run the initial setup on the switch to configure the IP address and other basic
system information. For complete details and instructions, refer to the AOS-W Quick Start Guide for the software version
installed on your switch.
Alcatel-Lucent 4306 OmniAccess Switch | [Doc Type]
Chapter 2
Alcatel-Lucent 4306
Installation
Alcatel-Lucent 4306 Installation | 13