Table of Contents
Advertisement
Cable specifications
(When connected to a personal computer)
Projector
Control commands
Command
Control contents
PON
Power on
POF
Power off
AVL
Volume
IIS
Input
Lamp condition
Q$S
query
OSH
AV mute
Computer connection guidance
You can switch the signals which to output from the COMPUTER1 OUT terminal by pressing the computer key
command. The key commands are depend on the manufactures. If you select the computer terminals which has no
signals while the INPUT GUIDE is set to DETAILED, the computer connection guidance will be displayed.
Manufacturer
Key command
Panasonic
NEC
FUJITSU
NOTE:
• The computer connection guidance will disappear after 5 minutes.
• Please refer the instructions which provided with the computers for more detailed information.
NC
NC
NC
NC
In standby mode, all commands other than the PON command are
ignored.
The PON command is ignored during lamp ON control.
If a PON command is received while the cooling fan is operating after the
lamp has switched off, the lamp is not turned back on again straight away
in order to protect the lamp.
Parameter
000 - 063 (Adjustment value 0 - 63)
Parameter:
VID = VIDEO
RG1 = COMPUTER1
Call back
0 = Standby
1 = Lamp on control active
Turning off the projection and sound temporarily.
Send the command to switch between on and off.
Do not send the command consecutively.
Manufacturer
TOSHIBA
SHARP
+
HP
EPSON
+
DELL
Technical Information
NC
NC
PC (DTE)
NC
NC
Remarks
SVD = S-VIDEO
RG2 = COMPUTER2
NWP = WIRELESS
2 = Lamp on
3 = Lamp off control active
Key command
Manufacturer
IBM
SONY
+
Apple
Other
+
Key command
+
+
E
NGLISH - 51
Advertisement
Chapters
Table of Contents
